Kit nastri protettivi per Optimist 29 pezzi
Il kit comprende 29 nastri tagliati o fustellati e dischi, selezionati tenendo conto delle regole di classe e pronti all’uso.
Il contenuto è utilizzabile per:
- deriva
- timone
- base albero
- fronte albero
- picco
Dettaglio del contenuto:
Stripes of UHMWPE with with acrylic adhesive on liner:
-2 stripes 500 micron (20mil) translucent, 25mm (1") wide, 380mm (15") long for the bottom daggerboard case
-2 stripes 250 micron (10mil) translucent, 25mm (1") wide, 380mm (15") long for the bottom daggerboard case
-2 stripes 250 micron (10mil) black, 20mm (4/5") wide, 270mm (12") long for the top daggerboard case
-1 stripe 125 micron (5mil) translucent, 40mm (8/5") wide, 740mm (27.5") for the boat corners/rudder
Stripes of PTFE with with silicon adhesive on liner:
-2 stripes 50 micron (2mil) grey, 50mm (2") wide, 150mm (6") long for the mast step
-2 stripes 250 micron (10mil) light grey, 60mm (2.36") wide, 150mm (6") long for the sprit
-2 stripes 50 micron (2mil) light grey, 40mm (4/5") wide, 100mm (4") long for the friction between mast and sprit
-2 stripes 50 micron (2mil) light grey, 40mm (4/5") wide, 80mm (3 1/5") long for the friction between sprit block and the mast
PTFE tape with silicon adhesive linerless:
-1 roll 50 micron (2mil) light grey 50mm (2") wide, 10m (11yds) long for rigging
PTFE disk to adjust the mast step level from 1mm to 7.5mm
-2 disks of 1mm
-1 disk of 1.5mm
-2 disks of 2mm
Rubber black
-4 short pieces to block the centreboard
-2 short pieces to block the centreboard